-

LPV versus LNAV/VNAV: what satellite-based augmentation changes for minima and equipment
On the same RNP approach chart, the LPV line and the LNAV/VNAV line do not announce two different heights by chance: they…
-

The Open-Fault Technical Interview in Maintenance, and What It Reveals
« A crew reports a slow pressure decay on a hydraulic system in cruise. No maintenance message, quantity stable, nothing on the ground.…
-

Evacuation Demonstration: What Certification Proves, and What It Doesn’t
In recurrent training, the question comes up almost every time: if an aircraft can be evacuated in ninety seconds during certification, why…
-

Long-Haul Light Scenario: What Cabin Lighting Does to Sleep on Board
Six hours from arrival, the ceiling shifts to amber, then goes dark. Outside it is broad daylight; at the destination it is…
-

Reduced Vertical Separation: What the Approval Actually Controls in the Altimetry Chain
An aircraft comes out of a check, airworthiness file complete, the two primary altimeters agree to the foot on the flight deck…
-

Airworthiness Directives: How an In-Service Finding Cascades Down to the Fleet
A mechanic finds a crack a few millimetres long at a stiffener, on an aircraft that has just come out of a…
-

Failed at selection: what stays on file, and how to reapply usefully
The rejection email runs to three lines and says nothing about the reason. A few months later, the same operator reposts the…
-

Sustainable Fuel Pathways: Why Only One Route Is Actually Available
A refuelling “with sustainable fuel” changes nothing the crew can see: the bowser still delivers Jet A-1, the delivery ticket carries the…
-

Two-Shift or Three-Shift Rest: The Real Effect on Vigilance at the Approach
Eleven hours of night flying, a full cabin crew, two ways of sharing in-flight rest: two shifts of about three hours each,…
-

Special Conditions in Certification: What They Reveal About a Novel Design
On a recent type, the flight manual bounds the use of equipment that the previous generation employed without restriction; in the maintenance…